/explore
|
You are here 
|
bwhitman.github.io | ||
| | | | |
blog.nuculabs.de
|
|
| | | | | Hi In this article we'll test out the PMS5003 sensor in order to see if it works. I've forgot to buy a connector board, so we will do a manual connection to the Raspberry Pi 3 B V2. This involves cutting the wires and adding some resistors. Please note that you need: 5 Jumper Wires 2 Resistors 10K Ohm Raspberry Pi Setup Before connecting the sensor to the Pi we need to configure the Pi for this usecase. | |
| | | | |
www.doctormonk.com
|
|
| | | | | DANGER: There is a really good chance that the battery is still holding quite a lot of energy. The fluid runs out first. So if, during disa... | |
| | | | |
coderdojoathenry.org
|
|
| | | | | Hello again everyone. I was away this week so Dave led the group, they did a couple of Arduino projects. They revisited the traffic lights from December but this time used the Arduino to control them and then moved on to a temperature and humidity sensor called the DHT11. Here is the wiring diagram... | |
| | | | |
www.crimeculture.com
|
|
| | | [AI summary] This post reviews the novel 'The Girl in the Red Coat' by Kate Hamer, detailing the plot of a young girl abducted by a preacher and the alternating perspectives of her mother and captive daughter. | ||
