/explore
|
You are here 
|
tobert.github.io | ||
| | | | |
esorensen.com
This page shows the process of modifying a Poppery II popcorn popper so that the motor and heater coils can be operated independently of each other. During the modification a thermistor is added to monitor the temperature of the coils and a thermocouple to monitor the chamber temperature. |
|
| | | | | ||
| | | | |
www.hsb-ats.com
HSB Applied Technology Solutions is a leading authority when it comes to sourcing and delivering IoT solutions inside the home. We identify the best possible partners to work with, guaranteeing quality through our deep technical knowledge, all backed by over 150 years of risk mitigation expertise. |
|
| | | | | ||
| | | | |
blog.asleson.org
A local contractor installed a new furnace and water heater for me on 1/21/2013. The install appeared to go well. The furnace is keeping our house warm and the water heater runs without making crazy noise and it is producing hot water. All is perfect in the world, well not quite... While checking out the water heater (AO Smith GDHE-50) I noticed that the lower side connect was quite cold, the brass drain was very cold too. My three other water heaters never exhibited anything like this when they had hot water in them. The valve and the side connectors were quite warm when the unit was at standby. |
|
| | | | | ||
| | | | |
blog.kiranshila.com
[AI summary] The author develops a new Rust driver crate for a power monitoring chip to support a global radio telescope project, highlighting improvements in embedded development tooling while discussing common pain points with I2C bus sharing and firmware flashing. |
|
| | | |||
