Explore >> Select a destination
|
You are here 
|
www.akpain.net | ||
| | | | |
willhaley.com
|
|
| | | | | You can use these instructions to create a bootable USB drive with GRUB that can run the Windows 10 installer. I used Arch Linux to prepare my USB device, but any Linux variant like Debian or Ubuntu should work. I am assuming you have an appropriately large USB disk at /dev/sdz that you can completely erase for this process. Unmount the USB drive if mounted. sudo umount /dev/sdz* Wipe all partitions from the USB device. | |
| | | | |
willhaley.com
|
|
| | | | | I have XP installed on a drive with a configuration like this. (In reality, each partition was 10x larger, but I'm using smaller numbers for this example). [ ~2GB FAT32 | E: (/dev/sda1) ] [ ~6GB NTFS | C: (/dev/sda2) ] [ ~2GB NTFS | F: (/dev/sda3) ] It may look unusual that C: is not the first partition, but a setup like this is not entirely unsual for an OEM hard drive. E: is a recovery/utility partition, C: is the partition with XP installed, and F: is an extra partition for backup. | |
| | | | |
cesarvr.io
|
|
| | | | | Arch Linux installation instruction for the impatient. Partition fdisk /dev/d #sda all disk in my case. #15 GB partition. Command (m for help): #type n and press Enter Partition type: Select (default p): #press Enter Partition number (1-4, default 1): #press Enter First sector (2048-209715199, default 2048): #press Enter start in the beginning. Last sector, +sectors or +size...(): #type +19G and press Enter. #SWAP 1GB Command (m for help): #type n and press Enter Partition type: Select (default p): #pres... | |
| | | | |
cookie.engineer
|
|
| | | Arch Linux Installation Guide (UEFI) | ||
