Explore >> Select a destination
|
You are here 
|
www.decarpentier.nl | ||
| | | | |
maxoffsky.com
|
|
| | | | | As you might know, I've been shifting my career focus from software engineering to hardware design and manufacturing. Specifically designing, [...] | |
| | | | |
tomscii.sig7.se
|
|
| | | | | ||
| | | | |
blog.alexellis.io
|
|
| | | | | PiWars is an exciting competition for makers of all ages - build a robot with a kit or design it yourself then complete a set of challenges for the win. | |
| | | | |
malwaretech.com
|
|
| | | Now that everything is ready to be connected, power up the hard drive an run openocd with the following command: openocd -f interface/<your interface here>.cfg -f target/test.cfg test.cfg should be the configuration for the CPU used by your hard disk controller, for most marvell CPUs this config should work. I'm not sure of the adapter_khz, so I've set mine to 100 (as long as this value is lower than the actual it should work). | ||
