/explore
|
You are here 
|
bcarrigan.com | ||
| | | | |
ciesie.com
|
|
| | | | | You programmed STM32 microcontroller using Nucleo or Discovery boards. That means you used Serial Wire Debug (SWD) for programming/debugging. Now, you are designing a PCB with a STM32 microcontroller on it, which means you have to be able to program it. One solution is uploading the code through a bootloader - a small piece of software, made by ST that has been saved in the protected (read-only) memory of the microcontroller. | |
| | | | |
jborza.com
|
|
| | | | | Over a month ago I bought an Altera Cyclone IV board from a local seller, it seems to be listed on Aliexpress as well. It's marked as A-C4E6E10, and features: Altera Cyclone IV EP4CE6E22C8 FPGA chip with 6272 logic elements, 270 Kbits of memory 8-digit seven-segment LCD display 8 position DIP switch VGA output PS/2 input port (comes in handy to try out keyboard processing) buzzer a couple of push buttons a handful of IO pins, some of which can be used as a connector for a 1602/12864 display and 22 miscellaneous pins CH340 USB to serial chip 1602 display has 2 lines of 16 characters, each 5x8 pixels 12864 dot matrix display has a resolution of 128x64 pixels, hence the name | |
| | | | |
www.scorpia.co.uk
|
|
| | | | | [AI summary] This article details the design and implementation of a POE-enabled lighting fixture with network control, focusing on hardware development, firmware, and integration with theatrical lighting systems. | |
| | | | |
bikerglen.com
|
|
| | | |||
