|
You are here |
lupyuen.org | ||
| | | | |
blog.drorgluska.com
|
|
| | | | | UI for Embedded is always a hassle, find the right MCU, find the right Display, connect the right wires and that's even before writing the f... | |
| | | | |
jborza.com
|
|
| | | | | Over a month ago I bought an Altera Cyclone IV board from a local seller, it seems to be listed on Aliexpress as well. It's marked as A-C4E6E10, and features: Altera Cyclone IV EP4CE6E22C8 FPGA chip with 6272 logic elements, 270 Kbits of memory 8-digit seven-segment LCD display 8 position DIP switch VGA output PS/2 input port (comes in handy to try out keyboard processing) buzzer a couple of push buttons a handful of IO pins, some of which can be used as a connector for a 1602/12864 display and 22 miscellaneous pins CH340 USB to serial chip 1602 display has 2 lines of 16 characters, each 5x8 pixels 12864 dot matrix display has a resolution of 128x64 pixels, hence the name | |
| | | | |
sergioprado.blog
|
|
| | | | | JTAG is a physical hardware interface that makes it possible, among other things, to extract the firmware image from electronic devices. | |
| | | | |
austinmorlan.com
|
|
| | | I recently purchased a new laptop (Dell XPS 13 9370) and needed to install Arch onto it. I thought I'd finally document the steps I took because I always seem to forget what I did the last time (one of the joys of Arch is that it rarely needs to be reinstalled). There are a lot of helpful guides online about different installation setups, but I could never find one that met all of my requirements: | ||