/explore

Click through on any links that interest you or select the planets on the right to continue exploring the Outer Web.
You are here

 yasoob.me
Connecting and Interfacing Raspberry Pi with Arduino - Yasoob Khalid
| | www.losant.com
Getting Started With the Raspberry Pi Zero W Without a Monitor
2.8 parsecs away

Travel
| | A Tutorial on Getting Started with the Raspberry Pi Zero W without a Monitor
| | blog.nuculabs.de
PMS5003 Particulate Matter Sensor Test Run | NucuLabs
2.8 parsecs away

Travel
| | Hi In this article we'll test out the PMS5003 sensor in order to see if it works. I've forgot to buy a connector board, so we will do a manual connection to the Raspberry Pi 3 B V2. This involves cutting the wires and adding some resistors. Please note that you need: 5 Jumper Wires 2 Resistors 10K Ohm Raspberry Pi Setup Before connecting the sensor to the Pi we need to configure the Pi for this usecase.
| | michaelscodingspot.com
Introduction to Arduino for sensors, robotics, and drones | Michael's Coding Spot
3.1 parsecs away

Travel
| | Michael Shpilt's Blog on .NET software development, C#, performance, debugging, and programming productivity
| | poolp.org
Install OpenBSD on dedibox with full-disk encryption ยท poolp.org
14.7 parsecs away

Travel
| TL;DR: I run several "dedibox" servers at online.net, all powered by OpenBSD. OpenBSD is not officially supported so you have to work-around. Running full-disk encrypted OpenBSD there is a piece of cake.