Explore >> Select a destination
|
You are here 
|
jonathanbayless.com | ||
| | | | |
www.40percent.club
|
|
| | | | | A blog about small mechanical keyboards. | |
| | | | |
blog.nuculabs.de
|
|
| | | | | Hi In this article we'll test out the PMS5003 sensor in order to see if it works. I've forgot to buy a connector board, so we will do a manual connection to the Raspberry Pi 3 B V2. This involves cutting the wires and adding some resistors. Please note that you need: 5 Jumper Wires 2 Resistors 10K Ohm Raspberry Pi Setup Before connecting the sensor to the Pi we need to configure the Pi for this usecase. | |
| | | | |
nathanfriend.com
|
|
| | | | | Remote Software Engineer at Stripe and cellist based out of Ontario. Previously at GitLab. Fascinated with building usable, delightful software. | |
| | | | |
denniskubes.com
|
|
| | | |||
