Outer Web | Explore

Explore >> Select a destination

You are here		gerritniezen.com Designing an open-source air quality monitor and building a community sensor network - Gerrit Niezen
\|	\|	www.doctormonk.com Dr. Monk's DIY Electronics Blog: Accessible FM Radio Case Study - Part 1	5.7 parsecs away Travel
\|	\|	[Part 2] [Part 3] [ Code and Design Files ] In this series of blog posts, I am going to document my journey (which I am about to start) ...	5.7 parsecs away Travel
\|	\|	guillaume.baierouge.fr guillaume savaton - au mouvant sillage	5.3 parsecs away Travel
\|	\|	[AI summary] This blog post details the design, assembly, and components of a homemade MIDI keyboard prototype called midi@3:14, focusing on its hardware, PCB layout, and future software integration.	5.3 parsecs away Travel
\|	\|	blog.brixit.nl Sensors and PCB design	4.0 parsecs away Travel
\|	\|	Designing electronics is neat. This is a look into designing my own ESP8266 based sensor board.	4.0 parsecs away Travel
\|	\|	sivantoledotech.wordpress.com Toaster-Oven Reflow Soldering without a Controller \| Eclectic Technical Experiences	33.8 parsecs away Travel
\|		Two circuit boards that I designed with Eagle use tiny components that I knew I could not solder with a soldering iron (chips in QFN packages and others). You can see one of the designs below. I was aware of two low-cost ways to solder them: with a hot plate, or in an oven. I...	33.8 parsecs away Travel