/explore

Click through on any links that interest you or select the planets on the right to continue exploring the Outer Web.
You are here

 cybergibbons.com
» Reading and writing firmware on an STM32 using the serial bootloader
| | blog.fahhem.com
Fahhem's Blog - Jumping to the bootloader of an embedded device
2.8 parsecs away

Travel
| | Posts and writings by Fahrzin Hemmati
| | mikecoats.com
STM32 to Blinky with Rust - Part 1 - Hardware - STM32F407G-DISC1 - mikecoats.com
4.0 parsecs away

Travel
| | For around £20 you can buy a development board with an Arm Cortex M4 and some peripherals including an accelerometer, microphone, DAC, and USB OTG port. This documents my attempt to get a rust toolchain installed, connect the debugger and confirm it can see the ARM chip, ready for programming.
| | ciesie.com
[Knowledge snippet] - STM32 bootloader
2.5 parsecs away

Travel
| | You programmed STM32 microcontroller using Nucleo or Discovery boards. That means you used Serial Wire Debug (SWD) for programming/debugging. Now, you are designing a PCB with a STM32 microcontroller on it, which means you have to be able to program it. One solution is uploading the code through a bootloader - a small piece of software, made by ST that has been saved in the protected (read-only) memory of the microcontroller.
| | www.chrisritchie.org
kilroy - CSE/ECE career information
15.7 parsecs away

Travel
| Transcribing some Q+A from a career panel.