Explore >> Select a destination


You are here

dumblebots.com
| | ncona.com
3.0 parsecs away

Travel
| | In my previous post, Getting Started With Arduino UNO R4, I showed how we can upload a sketch into an Arduino board. In this article, we are going to do the same, but this time using the Arduino CLI. Why Arduino CLI? I personally, use neovim for coding, which makes it a necessity for me to be able to compile and upload my code from my terminal. If you prefer the IDE, this article might not be for you, but, understanding the CLI could be useful in the future to automate repetitive tasks or run things in a...
| | www.playembedded.org
3.8 parsecs away

Travel
| | In this article, we will provide an introduction to microcontrollers, which are small computers on a single integrated circuit that are specifically designed to control various devices or systems. We will explore the key differences between
| | mcuoneclipse.com
4.0 parsecs away

Travel
| | Looking for something special? Or an article on a specific topic? Then this page hopefully helps you to find what you are looking for.
| | whatibroke.com
43.5 parsecs away

Travel
| Hi everyone, Just a quick post on how to configure wireless info on a raspberry pi. To start with, open the config file: sudo nano /etc/wpa_supplicant/wpa_supplicant.conf You can then add any number of connections to the file with varying priorities: ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev update_config=1 country=AU network={ ssid="Mobile Network" psk="YOUR_PASSWORD" key_mgmt=WPA-PSK priority=2 } network={ ssid="Home Network" psk="YOUR_PASSWORD"...